With the frosted duco finish cured, I am able to continue with the assembly and setup of The Crow. Both the headstock face and the back of the guitar are hand buffed to a gloss finish with a series of compounds. The next step is to remove any residue.
The nitro was flattened five percent to give it a slightly lower gloss. It’s hardly noticeable, but gives the guitar a more vintage and “lived in” appearance. The idea is to build a guitar that already looks and feels broken in and experienced.
In this shot you can see the ivory string nut. I like this material for a lot of reasons, including its rich, grained appearance. Any tape residue on the fingerboard is removed at this point; I go over each fret with a small hand buffer to shine them up.
Once cleaned up, the electronics are fitted in through small openings in the pickup routes. The Charlie Christian pickups are mounted on stainless steel shoulder bolts from the back of the guitar. You can see the mounting holes in the photo above.
Held from behind and cushioned on on springs, the pickups do not touch the top of the guitar. This allows the top to vibrate freely while the pickups are isolated for feedback rejection. It also gives the guitar a sleek look because there is no mounting hardware in the front. Height adjustments are done with a 4mm allen wrench.
After assembly, it’s time to put a set of Pyramid Nickel Classic strings on and do the setup. First I adjust the truss rod. From experience gained in thousands of set-ups, I can pretty much guess how much bow to put in even before the strings are on. I set the bridge to a middle height and then string up the guitar. With a close approximation of the final action, I then can cut the nut slots to their final depth. Then the guitar can be tuned to pitch and all the final heights and truss rod changes can be made.
To do the intonation I used my vintage Peterson strobe tuner on The Crow. I’ve had this tuner since the early 1970s and used it at Northern Prairie and the first Hamer shop in Palatine, Illinois. Here is a photo from the very first Hamer catalog—you can see the tuner in the shot. I'm wearing a tacky madras shirt that I bought in London’s Carnaby Street in April of 1973. I believe that is Martin Barre’s Standard on the bench.
And now, here is the crow on the bench in the new Dantzig shop. Same tuner, same tech, same procedure. Thirty seven years later and I’m still at it! Just for fun we colored the photo to match the original.
The last step is to intonate the guitar by adjusting the bridge saddles. First I set them to the 12th fret on the bench. Then I get the guitar in the playing position and tweak it from there. If you attempt to finish it on the bench while gravity pulls straight down, it’s going to be different when you put the guitar on your leg or on a strap.
After installing the truss rod cover, which is made from black ebony with a cellulose ivoroid binding, I trim the strings neatly. I’m going to jam on The Crow for a while to break it in more, and then it’s off to the photographer’s studio for some more formal portraits. I can’t wait to show them to you.